PhilS
Well-known member
Guys (and gals!)
Your opinions and expertise please.
I have just balanced my MK so that it balanced on the hinge pin by adding weights to the top of the stock using the narrow back of a chair as a fulcrum. Once balanced I weighed the lead used and it was 10oz!!
So, firstly is this excessive?? I was expecting 4 maybe 5oz.
Secondly how best to do this? The weights I used are wider than than the stock bolt hole but I could melt them down and make an ingot or two. This also leaves a possible dilemma of the available depth in the bolt hole not being sufficient.
Your thoughts and opinions folks please......
Your opinions and expertise please.
I have just balanced my MK so that it balanced on the hinge pin by adding weights to the top of the stock using the narrow back of a chair as a fulcrum. Once balanced I weighed the lead used and it was 10oz!!
So, firstly is this excessive?? I was expecting 4 maybe 5oz.
Secondly how best to do this? The weights I used are wider than than the stock bolt hole but I could melt them down and make an ingot or two. This also leaves a possible dilemma of the available depth in the bolt hole not being sufficient.
Your thoughts and opinions folks please......
Last edited by a moderator: