I’m sure GMK have them - I find it a lot more convenient to order directly from Beretta eu store . They are the same hp chokes as supplied with the A400 692 and DT11 black edition.
Hollow Farm Shooting Grounds just outside Comber . Good selection of new and used toys and a skeet, dtl and compact sporting layout to try them out. Gordon and Graham know what they are talking about and will keep you right .
Try PSHQ Europe webpage- they had both companions and side kicks listed as available. I’ve ordered Briley Choke tubes from them previously with no issues- might be worth a phone call ? 👍
Jasper
In addition to my A400Excel and Benelli Super Sport my O/U is a 525 Trap One for every reason you stayed in your earlier post but the op seems to be predisposed to Beretta and , in my opinion for what it’s worth, a new 690/ 686 Evo is a better investment than a Gold E of unknown provenance 🙈
£1800 is a lot for a Gold E of unknown provenance.. the last one I purchased (a fixed comb 32”) was new at £1690 ! In the unlikely event 🤔 you decide to p/x in the future your £2300 investment will be worth £1200-1400 (I’ve been there) . I’ve shot my mates 690 Black Edition 30” extensively which...
Your money your choice but......
if you intend to buy a £1800 Gold E and spend a further £500 on restoration why not buy a new 686 evo if you want a traditional 68 series action or a 690 and have a new gun for similar or less outlay and have a full warranty etc?
Edgar Brothers are the current Zoli importers and should have parts available. My Kronos came through the previous importer Steven J Fawcett who was advertising new old stock Z guns until fairly recently. Hope this helps.
I have always used contact lenses and 'normal' shooting glasses-Oakley. A recent eye injury and resulting treatment has meant that I have been advised to avoid contacts for eight to twelve weeks which means I am currently using my daily wear glasses with little success - lenses are too small and...
The bent lifter was original designed for the 390 not the later 391. If Gmk or The Beretta webstore supply one it will be the flat design. I doubt if either will keep an inventory of parts for an obsolete model (still the best auto beretta have made imo) I had a 391Teckys fitted with a 390...
I had the same problem with both my Sport 2 and Córdoba. Benelli's are notoriously finicky In this regard. The simple solution is to shorten the recoil spring approx 1 1/2 inches which should allow all 24 grain loads to cycle. It is a bit Heath Robinson but does work well .The alternative is too...